DMP Electronics SCS2 Manual de usuario descargar pdf (Pagina 40)

JTAG-Booster for AMD ÉlanSC520

40 JTAGEL5d.doc

/LENGTH=hhhhhh

The number of programmed bytes may be limited to LENGTH. If no LENGTH is

specified the whole file is programmed.

Abbreviation: /L=

/NODUMP

In case of a verify error the contents of the I²C-Device is written to a file with the

extension .DMP. With option /NODUMP you can suppress this feature.

/I2CCLK=pin_name

Specifies the CPU pin used for serial clock output.

/I2CDAT=pin_name

Specifies the CPU pin used for serial data input and output. Pin_name must

specify a bidirectional pin otherwise an error message occurs. Instead of one

bidirectional pin one pin for serial data input and one for serial data output may be

used. See option /I2CDATO= and /I2CDATI= .

/I2CDATO=pin_name

Specifies the CPU pin used for serial data output. Pin_name must specify a

output pin otherwise an error message occurs.

/I2CDATI=pin_name

Specifies the CPU pin used for serial data input. Pin_name must specify a input

pin otherwise an error message occurs.

Example: JTAGEL5 /PI2C EEPROM.CFG /I2CCLK=PIO31 /I2CDAT=PIO30

This example loads the file EEPROM.CFG to a serial EEPROM connected to the

pins PIO31 and PIO30 of the AMD ÉlanSC520

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 50 51

Sin comentarios

DMP Electronics SCS2 Manual de usuario Pagina 40