Dmp-electronics DMP Command Processor Panel XR500 Manual de usuario descargar pdf (Pagina 46)

XR500 Series Canadian Programming Guide Digital Monitoring Products

OUTPUT INFORMATION

Output Information

12.1

OUTPUT INFO

Output Information

This section allows you to program wireless outputs and name wired outputs.

12.2

OUTPUT NO. X X X

Output Number

Enteranoutputnumber.Entryrangeis1to6,450to474,480to499,500to999.

In order for wireless output troubles to display at a keypad, the keypad address must

bespeciedattheAuxiliary1ZonespromptintheStatusListprogramming.

12.3

OUTPUT NAME

Output Name

Thissectionallowsyoutodenea32characteralphanumericnameforanyoutput

numbers. The name can display on the keypad when a user performs the browser

featureatOutputsOn/Off.SeetheXR100/XR500User’sGuide(LT-0683CAN)

Appendix for browser operation.

12.4 Output Real-Time Status

SelectingYESallowsReal-TimeStatusreports,suchasOutputON,OFF,PULSE,or

TEMPORALtobesentusingPCLogreports.SelectingNOdisablesReal-TimeStatus

for this output device. Default is NO.

12.5

SERIAL#: XXXXXXXX

Serial Number

This option and the next option only display when the output number entered is for

awirelessoutput.Entertheeight-digitserialnumberfoundonthewirelessdevice.

ALREADY IN USE

OUTPUT NO: XXX

This message displays when the serial number is already programmed for another

output. The programmed output number displays.

12.6

SUPRVSN TIME: 240

Supervision Time

Press any top row key to select the supervision time required for the wireless

output. Press COMMAND to accept the default time. Default is 240 minutes.

Note:RefertotheWirelessCheck-inandSupervisionTimeDenitionssectionofthe

Appendix for supervision information.

SELECT MINUTES:

0 3 60 240

Press the Select key under the required number of minutes. The wireless output

must check in at least once during this time or a missing condition is indicated for

thatoutput.Zero(0)indicatesanunsupervisedtransmitter.

The 3 minute supervision time is only available if using an 1135 Wireless Siren.

Note: When the panel is reset, a receiver is installed or powered down and powered

up, or programming is complete, the supervision timer restarts for all wireless

outputs.

12.7 Trip with Panel Bell Option

This option displays when the wireless device is an 1135 wireless siren. Select YES to

have the 1135 wireless siren follow the panel’s bell output cadence for the zone type

and bell cutoff time up to 15 minutes. Default is YES.

OUTPUT REAL-TIME

STATUS

NO YES

TRIP WITH PANEL

BELL NO YES

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 84 85

Comentarios a estos manuales

Sin comentarios

Dmp-electronics DMP Command Processor Panel XR500 Manual de usuario Pagina 46

Comentarios a estos manuales

Relacionado con productos y manuales para La Seguridad Dmp-electronics DMP Command Processor Panel XR500